Slip yoke eliminator
#1
Senior Member
Thread Starter
Join Date: Dec 2011
Location: green bay WI
Posts: 890
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Grand Cherokee
Engine: 4.7
Slip yoke eliminator
I am looking to get one that's my next step in the project what are some good brands do I need to buy a custom drive shaft and should I do a drop kit for the lift? I have a nv247 tcase
#4
Senior Member
Thread Starter
Join Date: Dec 2011
Location: green bay WI
Posts: 890
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Grand Cherokee
Engine: 4.7
I might be swapping out to a nv242 if I can Find one but I don't know if one off and older gc fits or if one off an xj fits
#5
Tom Woods has a Short Shaft SYE kit for the NP242j, but it's very pricey.
Other than that your looking at a H&T kit.
http://www.seriousoffroadproducts.co...Path=1219_1245
As far as driveshafts are concerned...
https://www.cherokeeforum.com/f10/re...shafts-127026/
Other than that your looking at a H&T kit.
http://www.seriousoffroadproducts.co...Path=1219_1245
As far as driveshafts are concerned...
https://www.cherokeeforum.com/f10/re...shafts-127026/
#7
Member
Join Date: Aug 2009
Location: Centinnial, CO
Posts: 137
Likes: 0
Received 2 Likes
on
1 Post
Year: 2004
Model: Grand Cherokee
Engine: 4.7L V8
You are going to have problems doing a hack and tap on the 247. It has a hardened output shaft (hard to tap and cut) the 249 is the same. If you can find the correct 242 (input diameter there are 3 of them and length again 3 lengths) you will be golden for a h&t however if you want to open your xfercase and a 242 the inputs are swappable between 242's and 247/249's after I believe 96 manufacture year of a 242.
Trending Topics
#8
Senior Member
Thread Starter
Join Date: Dec 2011
Location: green bay WI
Posts: 890
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Grand Cherokee
Engine: 4.7
Originally Posted by lestatsghost
You are going to have problems doing a hack and tap on the 247. It has a hardened output shaft (hard to tap and cut) the 249 is the same. If you can find the correct 242 (input diameter there are 3 of them and length again 3 lengths) you will be golden for a h&t however if you want to open your xfercase and a 242 the inputs are swappable between 242's and 247/249's after I believe 96 manufacture year of a 242.
Thread
Thread Starter
Forum
Replies
Last Post
Raney120
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
22
10-16-2015 11:27 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)