Couple questions on upgrading the ignition
#1
Former Sponsor
Thread Starter
Join Date: Feb 2010
Location: Roanoke VA
Posts: 474
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Grand Cherokee
Engine: 4.0L
Couple questions on upgrading the ignition
Hey guys, getting ready to do another overhaul on the zj. I ordered the MSD Ignition Coil and some Accell 8mm wires. I replaced my cap and rotor about 4 months ago but it did not have the brass terminals. Should I get a new Cap and Rotor with the brass in order to get the most out of the ignition coil? Also, should I still just run the stock copper champion plugs? What gap? I was thinking about maybe opening them up another .005.
Last edited by mudfrog; 02-08-2011 at 06:39 AM.
#2
CF Veteran
Join Date: May 2010
Location: New Hampshire
Posts: 1,013
Likes: 0
Received 1 Like
on
1 Post
Year: 1997
Model: Grand Cherokee
Engine: 4.0
Good question. From my past experience with a performance coil and wires set, its safe to jump another 5 on the gap. Some can gain another .010 on the gap...HOWEVER I would recommend checking with MSD as they built this for the 4.0 and should have specs on recommended gap on these. Stock plugs are fine. Brass terminals is always a good way to go. These are recommended
Thread
Thread Starter
Forum
Replies
Last Post
jmarzo
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
16
10-18-2022 04:11 PM
MidwestNick
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
10
02-28-2016 02:05 AM
Tcq192
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
10-23-2015 09:25 AM
studmuffin
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
1
09-03-2015 06:59 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)