coolant sensor bad
#2
Resident Pirate
Join Date: Nov 2008
Location: Orlando-Chickamauga
Posts: 3,877
Likes: 0
Received 3 Likes
on
3 Posts
Year: 2001
Model: Cherokee
Engine: 4.0
The vic comes out after you remove the center of the dash iirc but the coolant sensor is something that pops up on a lot of zj's supposedly right before i got mine they had replaced it and it was popping back up....but that place did royally screw me over....
#3
Why are you removing the vic? If you already replaced the sensor it might be bad or you need to reset the vic. If this is the case, try removing the neg. on the battery and wait a couple minutes, then reconnect, this should reset it. Are you talking about the temp sending unit? Or the coolant sensor that is connected to the thermostat. The first one runs your gauge on dash (or light). The second one is easy to install, about 18.00 at AZ. The second one is a PITA.
#4
Seasoned Member
Join Date: Aug 2009
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Grand Cherokee
Engine: 4.0
haha this wont go away on either mine or my dads zj...i replaced the coolant level sensor and nothing it may be the coolant temp sensor. but i remember reading up on this and says its a common problem with zjs
#6
Junior Member
Join Date: Jul 2010
Location: Scotland, Ayrshire coast
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Grand Cherokee
Engine: 4.7 V8
Me too, the previous owner had my ZJ for 5 years and the message flashed up from the day they bought it - ignore
#7
Newbie
Thread Starter
Join Date: Aug 2010
Location: va
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Grand Cherokee
Engine: v8/5.2
Why are you removing the vic? If you already replaced the sensor it might be bad or you need to reset the vic. If this is the case, try removing the neg. on the battery and wait a couple minutes, then reconnect, this should reset it. Are you talking about the temp sending unit? Or the coolant sensor that is connected to the thermostat. The first one runs your gauge on dash (or light). The second one is easy to install, about 18.00 at AZ. The second one is a PITA.
Trending Topics
#8
Coolant Sensor Bad Fix
This error message is usually caused by a bad soldering joint between the plug and the circuit board inside the VIC, but it's an easy fix. All you need is a T10 torx bit, a phillips head screw driver, and a soldering iron. $9 soldering kit from radio shack worked like a champ. Here's step by step instructions:
http://www.jeepforum.com/forum/f13/c.../#post11719192
http://www.jeepforum.com/forum/f13/c.../#post11719192
#11
Newbie
Join Date: May 2011
Location: Littleton, Colorado
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Grand Cherokee
Engine: 5.2
i know three people including my self who have this problem thanks for thr tip on the soldering im going to do it right now cause it drives me bonkers
Thread
Thread Starter
Forum
Replies
Last Post
shelby5041
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
39
11-07-2015 01:22 AM
Tcq192
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
10-23-2015 09:25 AM
Ye Ol' Cherokee
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
10-09-2015 10:29 PM
neocracka
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
09-05-2015 06:50 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)