axle shafts?
#1
Senior Member
Thread Starter
Join Date: Jul 2010
Location: anacortes, wa
Posts: 536
Likes: 0
Received 1 Like
on
1 Post
Year: 1996
Model: Cherokee
Engine: 4.0 HO
axle shafts?
So I am looking to upgrade the axle shafts in my 96 zj wanted to know if these are worth the money http://www.ironrockoffroad.com/Merch..._Code=IR-XDAXL I would be getting the Both Sides with 760X U-Joints and Almost Alloy Kits Installed! I should throw it out there that I am rolling on 35s!
#4
OK, all joking aside. Mine is a 00 Obviously, with those shafts your looking at and I too am on 35's but 15" wide TSL's and am sitting with a snapped u-joint and it also ate the ears off the shafts in the event of it being broken. I know you could go to your local JY or salvage yard and get these your self alot cheaper. Just take a slide hammer with you, the hub assesmblies have a tendency to stick as they sit over time.
Hope this was a better response.
Hope this was a better response.
#5
CF Veteran
yeah, they'd be a good upgrade. worth the money, i guess.
you could also look into the super30 kit for comparison.
you could also look into the super30 kit for comparison.
#7
Check these out if your hung up on keeping your D30 alive and healthy.
https://www.rcvperformance.com/store...roducts_id=106
https://www.rcvperformance.com/store...roducts_id=106
Trending Topics
#9
The axle itself, yes, then comes the fabrication for the 4 link system. Either way, the RCV's have a "You break it, we replace it, no questions asked policy. That and with CV ends you can run a locker and turn while locked without the fear of damaging a u-joint or ears on shafts. Xtreme4x4, JP Magazine, Petersons and FW all have tested these and all were pleased. Only mod needed is a stock 44 from say a TJ RUBI, you have to widen the hub to slide the CV's in. I know it's alot more than his IRO shafts he's looking at..but supposedly their bulletproof. THe Baha G-wagons are starting to run these. No one who tries them are complaining.......yet
#10
CF Veteran
Join Date: Feb 2010
Location: Soddy Daisy TN
Posts: 5,420
Likes: 0
Received 0 Likes
on
0 Posts
Year: 97
Model: Cherokee
Engine: 4.0L
Those are stock shafts and not an upgrade. If you have CVs just keep them greased and good boots on them and they will be fine. Like others said, go to a jy if you want a set of these. I sold my last set for 25 bucks.
Thread
Thread Starter
Forum
Replies
Last Post
lgrant
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
07-05-2022 12:19 AM
cerami50
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
13
09-14-2015 10:28 PM
weswins
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
4
09-14-2015 10:09 AM
Ibanezz
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
24
09-10-2015 07:15 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)