aftermarket spring perches
#1
Junior Member
Thread Starter
Join Date: Sep 2012
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1994
Model: Grand Cherokee
Engine: 4.0
aftermarket spring perches
04 wj with rotted perches. Will need to replace entire assembly with prefabbed bought from a supplier. Found two that sell them , but I have no idea on making sure they are aligned properly before welding. Has anyone done these and what did you do. Thanks
#3
Seasoned Member
Join Date: May 2014
Location: Nor Cal
Posts: 371
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1993 & 1994
Model: Grand Cherokee
Engine: 4.0
I draw a rough sketch of the diff and then measure all the spacings and angles and write them in on my sketch. I do a rear and side view sketch to cover my bases and always take a overall picture so you know you are putting them in the correct orientation.
Max
Max
#4
Junior Member
Thread Starter
Join Date: Sep 2012
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1994
Model: Grand Cherokee
Engine: 4.0
Lots of measuring and a good sketch sounds like the way to go. Still keeping an eye out for a reasonable axle with good mounts. But my front end rides nice and every thing has been done to it already as far as bearings and axles. So would hate to have to change everything over. But price wise the new mounts put me close to a donor axle as far as cost. Definitely need to get this done before any lift I would put in. Probably do everything at the same time anyway. Thanks again.
Thread
Thread Starter
Forum
Replies
Last Post
Desertfox1023
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
12-01-2009 11:01 AM
importcrusher420
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
6
07-24-2009 01:47 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)