ABS light stays on..
 

Ok about a few years ago or so I replaced some wheel speed sensors on the front that were cut. So I went and replaced them. Problem is the light is still on. I've checked all the fuses that could cause a problem and nothing. I've checked the relay and the relay fuse is fine as well.. I've replaced both front left and right wheel speed sensors, twice. After I started up my Jeep and took off, the light went out, then shortly there after, the light came back on.

I have no idea what the hell is going on with this thing.. the Store Manager at Autozone said it sounds like the ABS Control Module, which isn't sold at store level.


Anybody else have any idea.

Side note- We ran a code read and it kept popping up $28 on both sensors...

No idea, HELP!

Clean the rust off your tone rings. They are the notched rings just under the sensors.

Same thing this you tube video said... check the tone rings and give them a good scrub.. rust, mud and dirt can block the signal from the sensors