96 jeep grand Cherokee Laredo
#1
Newbie
Thread Starter
Join Date: May 2017
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
96 jeep grand Cherokee Laredo
i have a 96 grand cherokee laredo and the lower front drivers side control arm and bracket are rusted right off the body is there any way to fix it as the rest of the body is great and theres ont 174000 KM on it
#2
Senior Member
Welcome to the forum.
Yes, the front lower control arms are retained to the body w/ formed four-wall box sections as-shown in the images.
Have someone create this part, or grind off the welds from a donor vehicle to snag a used part, remove the old, then weld on the replacement.
Yes, the front lower control arms are retained to the body w/ formed four-wall box sections as-shown in the images.
Have someone create this part, or grind off the welds from a donor vehicle to snag a used part, remove the old, then weld on the replacement.
#3
CF Veteran
Join Date: May 2012
Location: Lost in the wilds of Virginia
Posts: 7,964
Received 952 Likes
on
767 Posts
Year: 1998 Classic (I'll get it running soon....) and 02 Grand
Model: Cherokee (XJ)
Engine: 4.0
Welcome!
To the wrong forum!
This section is for the Cherokee. The Grand Cherokee section is over here.
To the wrong forum!
This section is for the Cherokee. The Grand Cherokee section is over here.
#4
Old fart with a wrench
Before you get too involved, look at the UPPER mounts and make sure the frame isn't cracked out already. Those are a lot harder to fix. My 97 ZJ broke out a rear lower arm mount and when fixing that, found the rest of the control arm mounts, both front and rear, were barely holding together. That's when I parted it out and bought "Jessica", my 2000 WJ.
Thread
Thread Starter
Forum
Replies
Last Post
Vanessa Bunch
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
1
08-20-2021 01:12 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)