I have a 1999 jeep grand cheokee WJ with the quadratrac 4.7L v8 and i put a 4" lift on it that i purchased from Rough Country. Before i bought the lift my front driveline (dual CV type) had the rear cv that bolts up to the t case go out so i removed the driveline while i gathered funds for the new one. I put the lift on and bought a new driveline, now i cant get the driveline to bolt up without it rubbing and ripping out all the boot and vibrating terribly i've tried everything i can think of! Any help would be greatly appreciated.
Thank you!!!

 

lower ur transfer case and it will level ur drive shaft out and stop the vibration

 

The lift came with a t case drop and when i drop the case it puts an upward angle on the output of the t case making the angle which the d line has to bolt up even more extreme lol

 

If you check RCs site it states not to use it with the CV style drive shaft just for that reason. I know on ZJs you can convert it to the u-joint style and I'm sure you could prob do the same with yours. Just need the u-joint style shaft and a new yoke for the front axle.

 

XJmarc
Any idea where i can find out wether or not i can switch to those or where i can get them?

 

rough countrys site haha thanx