bdub_xj

hello i am new to the site, just bought a 99 xj and am ordering the rustys 8 inch long arm. i was wondering if anyone has used any of the stuff from rustys, how did you like it? ease of install (i have a lift) quality? also says i can fit 35's but would it be a better decision to run 33's for clearance? i bought the jeep cheap it has been rolled over but runs strong low miles, i knew previous owners so got it for a good price i'll post some pics but would also like some input on how to get the roof back just good enough to get the doors to work properly (the doors are somehow not bent or twisted) thanks hope to get to know you guys as time goes on and maybe do some wheelin with some of you.

Jeeptunes

lloks like u need a porta power and someone to hold it in place until it has tension on it. its a nice looking jeep otherwise

DeftwillP

not a build thread

bdub_xj

thanks, i got the main bend in the center of the window out with a board and a floor jack on the pass seat lol im hoping that if i take the doors off i can pull the b-pillars out with a comealong and a couple trees and finish with a hammer lol but i was hoping someone on here had ran in to this problem before haha

rob93

I've seen people use a hi lift for getting the roof back into position above the doors