1994 Cherokee project
11-26-2010, 08:56 AM
#1
Junior Member
Thread Starter
Join Date: Nov 2010
Location: Maryland
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1994
Model: Cherokee
Engine: 4.0L I6 MPI "Power Tech HO" (High Output) - 190 hp @ 4750 rpm, 220 ft lb @ 4,000 rpm
1994 Cherokee project
I bought this 1994 Cherokee 4.0 high output, with 86,000 original miles, and turned around and had to weld an all new floor into it. it was rusted bad. After putting a galvanized floor into it, so it wont rust again! 
I got it inspected and had it on the road for $1,400.00 total. Then I started on the suspension, and installed 2 in spacers, on the front and 3in old man emu heavy duty leaf springs on the rear. Extended brake lines, quick disconnects and 31/10.50 General Grabber AT2's on American racing rims. Side steps and window tint were next. I am a welder so I have plans drawn up for a new front bumper, rear bumper and multiple skid plates!
future plans include fabbing a roof rack and bumpers, and 4" more lift with 35's new gears and a snorkel. Any suggestions would be great!
I got it inspected and had it on the road for $1,400.00 total. Then I started on the suspension, and installed 2 in spacers, on the front and 3in old man emu heavy duty leaf springs on the rear. Extended brake lines, quick disconnects and 31/10.50 General Grabber AT2's on American racing rims. Side steps and window tint were next. I am a welder so I have plans drawn up for a new front bumper, rear bumper and multiple skid plates!future plans include fabbing a roof rack and bumpers, and 4" more lift with 35's new gears and a snorkel. Any suggestions would be great!
Thread
Thread Starter
Forum
Replies
Last Post
jay_sco
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
09-10-2015 11:42 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)