1985 xj blue camo
#108
Seasoned Member
Thread Starter
Join Date: May 2011
Location: Nevada
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1985
Model: Cherokee
Engine: 5.7L V8
So doing the electrical went to autozone grabbed new wires for her found that I have to get new fuel pump, distributor, and I was planning on new red top optima battery this weekend should have time to put it all in this weekend also
#110
Member
Join Date: Sep 2012
Location: NW NY/S ONT
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1986
Model: Cherokee
Engine: 2.5
I found a console with cup holders too. It's gray and I'm considering painting it black to match the interior. How would you go about painting it or were you lucky enough to find a matching console? Also how you considering mounting it? I might just space it in with some wood shims at the back and fab a brake at the front....
#113
Seasoned Member
Thread Starter
Join Date: May 2011
Location: Nevada
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1985
Model: Cherokee
Engine: 5.7L V8
I went with the Novak motor mounts and the ax-15 transmission I bought all my stuff for this build from Novak. I will end up using the same spray paint that I used for the plastic molding for the center console also so it all matches there are tons of paints you can use for plastic trim and stuff just have to do the research and match the colors
#114
Seasoned Member
Thread Starter
Join Date: May 2011
Location: Nevada
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1985
Model: Cherokee
Engine: 5.7L V8
Go a lot of the electrical did it this past weekend need to get another battery had to put the one I bought into the wife's Honda o-well all in good time. Tons of work on the jeep this weekend if the weather hold up.
Last edited by Crashmurray1985; 02-01-2013 at 01:50 PM.
#115
Seasoned Member
Thread Starter
Join Date: May 2011
Location: Nevada
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1985
Model: Cherokee
Engine: 5.7L V8
So been busy on the build got all the electrical ran and ready to go also built a mount for the radiator and put the center console in along with the sifter. Need to get the fan blade for the motor the start the top of the radiator mount here are a couple of new pics just need to paint everything this weekend so it will match
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)