Originally Posted by LongArmXJ
there is a lot of talk about goin to haspin friday the 13th april.
|
where is that?
You make your marks i can get the shaft cut down at work this saturday. |
By chilicothy, will ya really? You weld up there too? Not sure if mine is up to the task
|
do you have a pic of what needs cut? that way i can see what you got goin on? as far as welding i can pretty decent but not sure if id want to do the drive shaft cause id feel bad if it broke lmao. I have a good friend that owns a shop in West Carrollton that is a super good welder, mig and tig. any metals too. His name is Jon down at Forced Fab. off of elm street on peirce rd/dr/st?
|
Where the slip yoke on the driveshaft that weld needs ground off so the yoke is free from the shaft, the shaft needs cut a couple inches then the yoke welded back on
|
if you got the yoke seperated from the shaft i could get a good straight cut on it at work. and the weld could get done at my buddies shop or you could use my welder.. that way the weld strength is on you lol.
|
Ok ill try to get it cut tomorrow,
|
My bead locks are going to be getting delivered tomorrow, time for some time consuming welds to be laid lol
|
Originally Posted by Customizer1000
(Post 1538346)
In middletown?
|
Originally Posted by LongArmXJ
My bead locks are going to be getting delivered tomorrow, time for some time consuming welds to be laid lol
|
Originally Posted by Hammbone
The one in Franklin. Before you get to Dayton Daily news. |
Off of 23.
|
Originally Posted by Customizer1000
(Post 1538467)
Hmmm didn't know there was a spot
|
The one off of 23?I hear its still being used for offroad purposes.doesnt mean cops like it
|
Originally Posted by Pnguyen7
(Post 1538481)
The one off of 23?I hear its still being used for offroad purposes.doesnt mean cops like it
|
All times are GMT -5. The time now is 08:51 PM. |
© 2024 MH Sub I, LLC dba Internet Brands