Anyone with Dana 30 experience?
The pinion in my LP Dana 30 is loose and I’m guessing the crush sleeve is in need of replacement. I only need to bandage the issue through summer while I build up my HP Dana 30, so I’d like to just pop the outer bearing, slip in a new sleeve, and slap it back together.
Anyone have experience swapping the crush sleeve in such a fashion? |
It should be easier than that even. Get yourself a new lock nut and replace it and tighten so it takes about 8 newton meters to turn the pinion. Then you will be done.
|
Are you sure it has a crush sleeve? Most Dana 30s use shims to set the pre-load on the pinion bearing.
|
Originally Posted by 4.3L XJ
(Post 3488833)
It should be easier than that even. Get yourself a new lock nut and replace it and tighten so it takes about 8 newton meters to turn the pinion. Then you will be done.
Originally Posted by 00t444e
(Post 3488836)
Are you sure it has a crush sleeve? Most Dana 30s use shims to set the pre-load on the pinion bearing.
|
All times are GMT -5. The time now is 12:16 AM. |
© 2024 MH Sub I, LLC dba Internet Brands