uber

that would be awesome! where you located?

uber

for today, worked on it a little bit more after work again. needed to replace an upper shock mount bolt that I managed to sheer off yesterday. oops.. haha. figured as long as I was buying a new one I should replace all 4 just to be on the safe side.

next I had to deal with the muffler we cut off yesterday. it was pretty trashed (and was hanging up one of my ebrake cables) so it got chopped. today I walked across the street and bought a cheap little cherry bomb turbo muffler and a bunch of little bits to get it attached and mounted. unfortunately my buddy cut the pipe a little too close to the cat, so I didn't have enough room to install it. so naturally I just said ****it and cut the cat off, and put the muffler there. hahaha.. I just had my inspection done for tabs a couple months ago, so I'm not too worried about it. sounds angry now, and frees up a lot of space underneath for when I inevitably find stuff to shove up under there.

bit of bad news tho.. when we yarded the old muffler I discovered that she was hiding a rusted out hole in my floorboard. .. so now I gotta figure out what I'm gonna do about that. pretty frustrating, but **** happens I guess.

straightsixjeep

Perfection clutch started to shudder after 5k miles, pulled the trans and right off the bat the throwout bearing is broken. -

Clean_95

I got a screamin good deal on a set of 16" ultra aluminum wheels today. Got 'em home to find they're 5x5.5
Now the search for wheels continues.
Know anyone interested? Onalaska, wa 98570

Phone won't let me add pics =\

Cherokee.Dreamer

Just get wheel adaptors

Just Another XJ from AK

Changed the oil and cleaned the engine.

navyjeeper01

Put new pioneer speakers in and replaced all the ****ty rusty screws I could find on the pig

uber

progress

Clean_95

I'm considering that for sure. We'll see what happens.

un4gvn1

I'm looking at the floor & cabinets in the background...You doing this in your kitchen?

If so, I am sooo jealous!

uber

lol, no.. i work at car toys and am working on it in the shop. wish i had a garage at home to work in, but this works

Westy

My question, is whats with those tires :P

uber

yeah, about that.. haha.. my alignment was all kinds of effed on that thing. as soon as this is done she's going to get one done. then it's straight to craigslist to find a couple replacements. rears are still pretty decent

Clean_95

Got my CB installed.... Almost!
Single 4' firestick for now. I have a 52" whip but need the threaded base.
Just need to get ground situated & crimp a spade on hot. Then wrap wires so they don't get kicked around & tie up under dash.
I always wire power to a ignition hot in fuse panel so radio only has power when key is on.

Tried to chase down the cable end for the roof mounted antenna... But had no luck. I did find a ton of aftermarket wiring & relays. That & the 10-12 holes in the dash & console pretty much has me convinced it is a retired police rig.
Also set up for a tow bar up front. Can't figure that one out.... And way low miles for any fleet vehicle. Only 173,000 wonder how many miles were in tow!

Dirt Diver

Dropped it off with a friend at A local big brand auto service center before I went to Texas with this: Just picked it up with this: No charge...he's a fellow Cherokee owner...that's Jeeper camaraderie!