Wire ID engine bay
 

Hello,

So I'm finally getting around to finishing my MJ restoration, I'm using the wiring harness from a 93 XJ. It's been 2 years since I re-did the wiring harness in for the engine and of course I can't find my notes for the wires in the photo. All I remember is the XJ came with them cut/broken out of the harness. I'm assuming that 3 of them belong to speed sensor? Any help with their ID would be great!

The wire colors are:
black orange
black white
black blue
black tan
orange
tan yellow
https://cimg0.ibsrv.net/gimg/www.che...bfcc9ddce4.jpg
https://cimg1.ibsrv.net/gimg/www.che...eed4a5ff5e.jpg

See if anything matches up in the 1991 or 1995 wiring diagrams here
http://jeep-manual.ru/index.php?page=XJ-2

https://cimg0.ibsrv.net/gimg/www.che...59e2f7d2ce.jpg
https://cimg4.ibsrv.net/gimg/www.che...c17c9554e5.jpg
I know there is / was a thread on this topic before but I can't seem to find it anymore... does anyone know what this connector is supposed to go to? Blue 2 pin connector with black/red and yellow/black wires comes off one of the transmission connectors if memory serves its on a 98 jeep cherokee 4dr 2wd. Know where everything else goes just can't figure this one out or find it on any diagram.