unibody structure needed?
#1
Member
Thread Starter
unibody structure needed?
Ok i plan on ordering the Rusty's 3 inch full spring lift kit and i know i need a rear drive shaft and could need a SYE but what about the over all unibody structure? do i NEED frame stiffeners or anything in that category. this is a street queen with some mild wheeling. I just do not want major problems with the structure of the jeep.
Thank you for all the input. Every little bit of info is greatly appreciated.
Thank you for all the input. Every little bit of info is greatly appreciated.
#2
For a 3 inch lift you do not need any frame stiffeners and will not need a SYE. You will not need a new driveshaft unless your is damaged. If you have any vibrations in the driveline after the lift the most you will need is a transfer case drop kit.
#3
CF Veteran
Join Date: Mar 2009
Location: Tenn. and Mich.
Posts: 28,068
Likes: 0
Received 6 Likes
on
6 Posts
Year: 2004
Model: Grand Cherokee
Engine: 4.7L V8
Ok i plan on ordering the Rusty's 3 inch full spring lift kit and i know i need a rear drive shaft and could need a SYE but what about the over all unibody structure? do i NEED frame stiffeners or anything in that category. this is a street queen with some mild wheeling. I just do not want major problems with the structure of the jeep.
Thank you for all the input. Every little bit of info is greatly appreciated.
Thank you for all the input. Every little bit of info is greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
2000CHERO
Modified XJ Cherokee Tech
20
10-12-2015 11:03 PM
william50
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
08-31-2015 02:19 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)