Thank you pioneer and sony
 

The only fix for all the ticks and knocks on my cherokee is some good loud speakers

Amen, brother!!

I have two Polk Audio 8's and they are amazing. And pretty cheap.

I have a pioneer reciever any sony xplod 4x6s and 6x9s i blew my pioneer 10" so im savin for 12" alpine type r

This thread made me lol.

Now... how to make the radio reduce oil leaking and overheating. If Sony or Pioneer does that, they'll make a killing from the XJ community.

That they will lol thats y savin for the alpine is slow....got bigger fish

I wish there was some sort of conversion to put a double din navi in the dash. Anyone know how one could be made to fit?

Not me

I agree I have 5 1/4 Kenwood doors and Kenwood 6x9s in boxes on back seat and a Kenwood 12 sub and of course a Kenwood deck. Just blew my Kenwood amp so I'm runninga Sony x-plod for now hits hard and sounds great and now jeep noises except rattle...lol

Yeah, I do believe there is a way to make it fit... More of a retrofit than a conversion kit however.. On the pre-96(I believe, not sure about later years), you can take out the center vent, move the climate control panel to the lowest slot, and then a double din system should be mountable. I have seen one with the "popout" style screen on an xj, tho I cant remember where i found the pic.. Should be sort of similar to this setup in the wrangler here..Probably a little more homebrew look in the xj however.
Attachment 385141
Again probably not quite what you had in mind, but its the only bit I can chip in...Short of cutting the dash up! :thumbup1:

sound is great
 

I am running a total kicker system 6.5" in both doors and back with one l3 solo baric. had to install an extra batt to keep the head lights from dimming. painted the jeep with raptor liner so no dyna mat needed. I love the looks I get pulling up to a red light blairing CCR

speaking of adding a battery how would you go about doing that and keeping it charged?

Its called an isolator they have them at part stores

so the isolator would get installed after the alternater right? then basically rewire the batteries in to the isolator?

U wire the alt to the isolator then wire the batters to it when u buy one it will come with diagrams

I ran 4 gauge wire from the batt to the rear (street wire kit) with a amp dist block. then use a sealed batt in a after market batt box. hooked the batt to a ground and then to the amp block. I'll take pics and upload them to my profile today...pics are loaded.