Chiefrocka

Wondering if a 91 t/c will we work in my 94 ?

RTorrez1

Are you going to give any kind of info other then years?Why do so many new people think that everyone here can read minds.
Here is a bad answer for a bad question. Sure it will just pull one out of a 91 Chevy 1 ton p/u and just drop it right in your Jeep.

TheJerm

yes

Chiefrocka

You ****ing dumb ***....this is a cherokee forum, what the **** would I be talking about ????

You sir are a douce !!

salad

Nice. How to get a thread locked in 4 posts or less.

Depends on the transmission and engine. This page has a little table that shows some combining factors: http://www.novak-adapt.com/knowledge...nput_gears.htm

Chiefrocka

Yeap for sure. Dont care if it gets locked. My question was simple and obvious.... No need for some idiots sarcasim.

The above person who replied "yes" knows whats up.

Simple question bro ....

salad

Not really. If you had clicked the link, you'd know that if one of them has an AX-15, the spline count will be different and it won't work. You could also have been referring to a ZJ, which has a different length input shaft AND a different spline count.

But, if you'd rather not provide details and then flip out when someone calls you on it, then by all means feel free to waste your own time and money. All you'll get out of a few hundred bucks and half a day of labor is "herpaderpderp, guess I shoulda clarified instead of being a dick". People post here because they like to, nobody is obligated to help or read your mind. And they especially won't if you act like an ****.

Chiefrocka

Obviously gonna pull from a Yeep the same tranny as mine ...

I did not provide details, because the only thing different is the years.

Otherwise, I would have.

My point is why come out so sarcastic....no need for that.

Im on other forums, where this type of behavior is not tolerated.

Chiefrocka

If I had clicked the link ?

You mean the one YOU presented AFTER the fact ??

Come on bro, give it up.

Manual is different than Auto ??

Gee thanks for clearing that up

TheJerm

I thought it was a pretty simple question. Ive never had issues with the long/med/short inputs during swaps. The only issue is mixing 21 spline renix with later 23 spline. Simple input shaft swap tho