LittleRed94

Was removing the passenger fender and I stripped the head on the lower T25 facing the door. Last thing holding on my fender.
Too tight in there for me to cut a notch in it with a dremel and use a flat head to get it out.
Tomorrow I'm gonna try putting electric tape over my bit and going at it with an impact driver.

Any ideas y'all can throw at me that might help?

rusty_bucket

That stinks, yeah, sounds like your last option.

BruceB

Lisle Oration LS62110 Stripped Screw ExtractorSix Lobed Spiral Bits are designed to remove rounded or stripped fasteners with internal drive heads. Four sizes of extractors fit Torx and Torx Plus sizes T-40 to T-55; ...more »
$26.82
+$1.88 tax and $10.15 shipping
Walmart - UnbeatableSale

caged

^those work great, as long as you are deep enough for them to bite into something.

otherwise, try hitting your bit into the head of the bolt with a hammer.

there is another tool that comes in handy for this type of job, if you have the room to get it in there.