slave cylinder repacement
 

Before I start and possibly screw it up. Is there a nything I have to do particular about removing the retaining pin. Looks like it just pulls out. Does the new one just push right in?

Correct..Lower left portion has a reataining washer looking thing just pops right out with a little convincing :hammer: and itll come right off that shaft.

that is on internaly mounted units..

I need t replace the pin to though. Does it pull straight out? Does new pin just pop in?

Yes I had to use a pair of needle nose on mine.. new part should come with new rataining nut. but im not sure ..But yes new one will just pop right in..

Cool thanks for your help. I have both new. Pin and clip

did it come with the slave cylinder?

Yes. It was a whole kit. Clutch, pressure plate, and slave cylinder with pin and retaining clip