rear ds question-h&t
#1
Registered Users
Thread Starter
Join Date: Nov 2008
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0l
rear ds question-h&t
Well i ordered my hack n tap a few days ago and i was just curious how to measure the drive shaft to know where to cut the output shaft. It says to measure from the inside of the u joint saddle on the rear end wich i understand but do you measure up to the output shaft then down it or just up to it? this is the first vehicle i've ever needed to do anything to the driveshaft. these are the directions with the kit.
http://www.ironrockoffroad.com/Merch...%20Install.pdf
http://www.ironrockoffroad.com/Merch...%20Install.pdf
Thread
Thread Starter
Forum
Replies
Last Post
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)