Please help,Clutch problem. Not going into gear
Just got 89 4.0 5spd randomly at a complete stop somtimes it wont go into any gear, Release point is also low...i bleed it and it got allot better but only for around 24 hours or about 50 miles of driving now today if i can get it into a gear it will start to slowley roll even with my foot engauging the clutch to the floor. Can anyone help please
|
sounds like you need a new slave cylinder....mine was slowly leaking inside the bell housing, causing a big loss in pressure....check and see if you are losing and fluid
just a thought |
I am leaking fluided at first i thought i dident tighten the bleeder properly..Then i noticed a drip coming off the center bottom of the case, I put it off as maybe real main seal causei seemed to be loosing some oil.Would the fluid find its way out of the casing? and also it is an internaly fixed slace cylinder located inside of the mx-15 right? and also is that tranny code right? sorry haha
|
ax-15
|
yes it can leak out of the bell housing since there is no seal between the trans and the engine....mine is the same trans and yes the slave cylinder is inside. and its a PITA cuz u gotta pull the trans
|
All times are GMT -5. The time now is 02:25 PM. |
© 2024 MH Sub I, LLC dba Internet Brands