Originally Posted by freegdr (Post 788150)

do you have a manual mine reads you can put it on the pan if you use conytact glue so it dont move , did you put in a rear main seal it gos in a certain way

Originally Posted by HCCAFan (Post 788160)

Thanks for the manual. Will read it over.

Yeah the RMS has some lips on it. We faced the lips towards the front of the engine, like Alldata said.

The RMS never leaked before I took the pan off to replace the oil pump so I'm not convinced it is leaking now.

Originally Posted by spiceman (Post 788193)

when i did my main and pan gasket the 1piece fel pro was a pain in the *** around the back of the pan... it leaked everytime. what i did was cut off the back part of the gasket, and use silicone on it... that worked.

the gasket just doesn't sit against the pan very well in the back and the gasket has to sit in the groove or else it will leak very badly....

i had to do it several times

Originally Posted by freegdr (Post 788166)

did you use a cork gacket this is a felpro one pc silicone

Originally Posted by freegdr (Post 788169)

was that the way the other seal was on

Originally Posted by freegdr (Post 788184)

found thishttp://go.jeep-xj.info/HowtoRearMain.htm

Originally Posted by freegdr (Post 788198)

first time her no probs ive prob done 30 oil pumps in my life time that prob helps also

Originally Posted by freegdr (Post 788210)

those are the only to areas that low that can be leaking oil 100 percent it not coming from above