not normal renix issue
 

ok so checked threads cant find nothing,
i have an 88 renix that was rebuilt 2 years ago then sat because freeze plugs went bad.
anyway it wont fire without ether, and sometimes it will fire up then shut right off without the ether.
when it starts it runs crappy and wants to die and if its put in gear with the pedal to the floor it does about 2mph then will die out
the coil is brand new along with the plugs,wires,fuel pump,and filter
usually i know my jeep stuff but this has me stumped

i had something somewhat similar happen. my ballast resistor was unplugged. the truck would start but just die instantly. the resistor is located on the driver side fender.

thanks i noticed it has to wire running to it can i just splice them together or would i need to replace

I would replace it rather then bypass it

that resistor lowers voltage to the fuel pump to help the pump run cooler. it is bypassed during startup and at full throttle. one of the relays near the battery controls it. if you pull the relay and jump the connectors, you can get the pump to run continuously. or put a DVOM on your resistor and make sure its not open.

zedpapa

10-4 but i also do not think this will solve its crappy idle
maybe egr?

It could be the reason for the crappy idle. Also, it might be your IAC.

After you clean your IAC
 

After cleaning your IAC you may want to fiddle a bit with your TPS or throttle position sensor..its the IAC's neighbor there on the throttle body.

define crappy idle. could be time to pull the egr valve and clean it out along with the IAC motor. i would also check all the vacuum lines to make sure you don't have a leak anywhere. take a look at the throttle body and make sure its not to dirty. have you checked the adjustment of your TPS? that being out could cause a "crappy" idle. also should check the coolant temp sensor. the one in the block, not the head. if it is sending the wrong info, you could be getting the wrong amount of fuel. time to spend some time with a DVOM and your jeep.

zedpapa

thanks guys this is the stuff i was hoping to see to give me a good solid
start somewhere will start checking nowq

bypassed the ballast did absolutely nothing

Maybe this Renix info will help.>-> http://web.archive.org/web/200803151...iagnostics.htm

im thinking my cps may be bad,if so will it still start off starting fluid or no?
without the spray it will just fire then die
also i flushed my cooling system and its pouring water from backside of motor??
any suggestions guys