no TQ's in drive
03-13-2016, 05:40 PM
#16
CF Veteran
Join Date: Aug 2010
Location: Canton, MI
Posts: 8,357
Likes: 0
Received 81 Likes
on
66 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
Because it's intended for the '97-'01. The '96 has different pin out on the connector and I never got around to developing a checklist for the '96 and prior.
03-13-2016, 05:47 PM
#18
CF Veteran
Join Date: Aug 2010
Location: Canton, MI
Posts: 8,357
Likes: 0
Received 81 Likes
on
66 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
Okay so I replaced the nss with a new one. The check engine light went away for a while. Now today it came back, same symptoms as before. No power in D but if I go into 1-2 I can accelerate. If I disconnect the battery for a couple minutes the check engine light goes away and it will drive fine. Then after a while it will come back and have no power in drive again..
If it was the tcm wouldn't i have no power in D all the time, even after I disconnect the battery? And the solenoids, if they were bad wouldn't it always have and issue even if the computer is reset? I'm thinking about just getting a new tranny.
Anyone have these issues?
If it was the tcm wouldn't i have no power in D all the time, even after I disconnect the battery? And the solenoids, if they were bad wouldn't it always have and issue even if the computer is reset? I'm thinking about just getting a new tranny.
Anyone have these issues?
Did you go through the test procedures (above)? Doesn't seem like it.
03-13-2016, 08:59 PM
#19
Member
Join Date: Jul 2015
Location: Fort Worth, TX
Posts: 206
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Engine: 4.0
Try adjusting the throttle valve cable
Edit.. Never mind, just realized you were getting a CEL as well as loss of power which means it's probably not the TV cable, but it wouldn't hurt to adjust it.
Edit.. Never mind, just realized you were getting a CEL as well as loss of power which means it's probably not the TV cable, but it wouldn't hurt to adjust it.
03-14-2016, 07:53 PM
#20
Newbie
Thread Starter
Join Date: Jan 2016
Location: Northern New Jersey
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
I plugged the scanner in today.
Codes:
P0758
P0700
I have new solenoids coming this week along with trans filter. Everything I have read about these two codes are fixed by replacing the solenoids. Looks like I'll be dropping the pan this weekend
Codes:
P0758
P0700
I have new solenoids coming this week along with trans filter. Everything I have read about these two codes are fixed by replacing the solenoids. Looks like I'll be dropping the pan this weekend
03-19-2016, 10:37 PM
#21
Newbie
Thread Starter
Join Date: Jan 2016
Location: Northern New Jersey
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1997
Model: Cherokee
Replaced the solenoids and filter yesterday night. Waited for the rtv to cure overnight till today. Filled the trans with fluids, and my xj has never ran better. The worst part about the job was getting covered in transmission fluid lol.
Thanks again everyone for the help
Thanks again everyone for the help
Thread
Thread Starter
Forum
Replies
Last Post
granduser
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
5
03-16-2016 12:54 AM
Carl Alexander
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
5
02-13-2016 08:06 AM
SteveMongr
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
19
01-30-2016 11:12 AM
Guntar13
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
6
01-29-2016 03:16 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
