Jeep Cherokee Forum

Jeep Cherokee Forum (https://www.cherokeeforum.com/)
-   Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here (https://www.cherokeeforum.com/f2/)
-   -   No start- charged battery and lights work (https://www.cherokeeforum.com/f2/no-start-charged-battery-lights-work-92035/)

xj yj 06-07-2011 02:44 PM
No start- charged battery and lights work
 
I know this is a cherokee forum but I have a 91 wrangler as well as a cherokee and the yj wont start. Battery is all charged up (checked it with a tester) but there is not even a clicking sound when turning the ignition. The lights work fine too. I put a screwdriver across the two bolts on the starter and nothing happened even when turning the ignition. Could the starter be bad or is this a connection problem.

Thanks

Bustedback 06-07-2011 03:13 PM
Put a 12volt test light on the small terminal on the solenoid and see if it lights up when turning the key to the crank position.

Solomon7 06-07-2011 03:22 PM
Mine did that when the CPS went out. They're cheap and easy to replace with a few wobble extensions.
Viewed from front it's at 11 o'clock on the trans bell housing.

Bustedback 06-07-2011 04:24 PM
A CPS will not cause the engine not to turn over, only a no spark condition.

sycoglitch 06-07-2011 04:32 PM
Turn ignition too accessory shift down all the way then too neutral then start. I know I should ask if you wrangler is auto, I know most ain't but it really sounds like a NSS. Good luck either way

tjwalker 06-07-2011 06:02 PM
Originally Posted by sycoglitch (Post 1032951)
Turn ignition too accessory shift down all the way then too neutral then start. I know I should ask if you wrangler is auto, I know most ain't but it really sounds like a NSS. Good luck either way
Agreed. If it's an automatic, try starting in neutral or try starting while "wiggling" the shift lever. If either of these techniques allows the engine to turn over, the problem is the neutral safety switch.

Here is a link to "refurbishing" that part.

http://go.jeep-xj.info/HowtoNSSrebuild.htm

freegdr 06-07-2011 06:05 PM
Originally Posted by xj yj (Post 1032778)
I know this is a cherokee forum but I have a 91 wrangler as well as a cherokee and the yj wont start. Battery is all charged up (checked it with a tester) but there is not even a clicking sound when turning the ignition. The lights work fine too. I put a screwdriver across the two bolts on the starter and nothing happened even when turning the ignition. Could the starter be bad or is this a connection problem.

Thanks
check for 12volts on large post on starter crossing these two bolts on starter should make it engage if theres current to large stud


All times are GMT -5. The time now is 10:28 PM.


© 2024 MH Sub I, LLC dba Internet Brands