renix push button start...now no temp?
#1
CF Veteran
Thread Starter
Join Date: Nov 2011
Location: Edmonton
Posts: 2,322
Likes: 0
Received 1 Like
on
1 Post
Year: 1990
Model: Cherokee
Engine: 4.0
renix push button start...now no temp?
As the title says...temp gauge does not work after push button start. Didn't think any column wiring had anything to do with this but...hoping someone has had a similar issue and found the solution before I have to go back in there. Thanks!
#2
::CF Moderator::
Join Date: Aug 2011
Location: Prescott, Az
Posts: 43,867
Received 1,524 Likes
on
1,236 Posts
Year: 1990
Model: Cherokee (XJ)
Engine: 4.0
Retrace your steps. Only temp gauge inop?
Did you knock the temp sender wire off the back of the head while running any new wires?
Did you knock the temp sender wire off the back of the head while running any new wires?
#3
CF Veteran
Thread Starter
Join Date: Nov 2011
Location: Edmonton
Posts: 2,322
Likes: 0
Received 1 Like
on
1 Post
Year: 1990
Model: Cherokee
Engine: 4.0
All the work I did was under the dash at the column...when I turn my acc/ign switch on, the temp needle pegs itself immediately. Then I hit the start button. After it fires up and runs, the needle falls back to zero...and even after a highway trip, it won't move. Weird. Maybe its a ground?
Last edited by hankthetank; 03-26-2012 at 08:24 AM.
Thread
Thread Starter
Forum
Replies
Last Post
daddytuck
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
09-07-2015 08:16 PM
DaFisch
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
09-06-2015 02:38 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)