Jeep wont start unless gas pedel is to the floor
#1
Junior Member
Thread Starter
Join Date: Jan 2014
Location: Idaho
Posts: 49
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0 inline 6
Jeep wont start unless gas pedel is to the floor
I have a 1996 jeep Cherokee 4.0 Manual 4wd. Today after work I went to start my car and all I got was cranking. Put the gas pedal to the floor and it started right up. In the last month I've replaced the ICU, CPS, plugs, wires, cap, rotor, and TPS. Any other ideas would help. Thanks
#4
Senior Member
Join Date: Apr 2015
Location: Connecticut
Posts: 734
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1995
Model: Cherokee
Engine: 4.0
Sounds like TPS. I read you replaced it but it's not unheard of to get a bad one. Link below to a similar issue. You getting any CEL's?
https://www.cherokeeforum.com/f2/xj-...floored-49323/
https://www.cherokeeforum.com/f2/xj-...floored-49323/
#5
Beach Bum
When this has randomly happened in my 1996, I get a CEL code for the ECT sensor/wire harness, Engine Coolant Temperature.
Trending Topics
#8
Beach Bum
#11
Newbie
Join Date: Apr 2014
Location: NV
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Year: 97
Model: Cherokee
Engine: 4.0
o2 sensor
Pushing the pedal to the floor cuts injector flow in half. A whIle ago my upstream oxygen sensor wires melted against the exhaust and I had the same issue and it ran decently otherwise. So you might check the sensor and wiring. Although I did have a check engine light at that point
Thread
Thread Starter
Forum
Replies
Last Post
zumer715
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
07-08-2022 05:17 PM
clangstaff
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
3
05-30-2019 10:34 AM
XJ ONLY
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
01-26-2019 06:30 PM
Gtrsrlly
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
5
08-25-2015 11:50 AM
zhunt728
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
08-20-2015 12:37 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)