jb weld on exhaust?
#1
Member
Thread Starter
Join Date: Mar 2009
Posts: 148
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0
jb weld on exhaust?
ok. i have a leak in my exhaust manifold. cracked right at the collector. no room to weld it..but maybe jb weld and some metal tape and a clamp? this is just temporary until i can save to do a complete exhaust overhaul.... but is it worth the trouble?
#3
Senior Member
Join Date: May 2009
Location: Middlesex County CT
Posts: 559
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1993
Model: Cherokee
Engine: 4.0 H.O
Vibrations will prob rattle it off. But it might hold for a little while as long as you clean the manifold down to the bare metal and let it fully cure before you start it again.
#5
Junior Member
Join Date: Jun 2009
Location: Tustin, Ca
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Model: Cherokee
I tried this once and the JB weld gets so hot that it became very brittle and basically just started crumbling off. Also, the smell of hot, smoking JB weld is terrible.
#6
CF Veteran
get one with a flex piece in the manifold, that will save you from ever having to do the job again.
it's a poor factory design, and if you use jb weld, or a welder for that matter, it will just crack again.
it's a poor factory design, and if you use jb weld, or a welder for that matter, it will just crack again.
#7
Newbie
Join Date: Jan 2009
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0
try some "water weld" made by JB weld. I used it on my buddys transmission and its an amazing solid seal. you cen get it anywhere you get j b weld. its like 4 bucks.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
jmsummers2012
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
53
04-30-2021 02:35 PM
libengan
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
14
11-06-2015 09:16 AM
MightyMouse8
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
14
10-08-2015 08:57 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)