LoganJeep

I will do what it takes to get 33's i was going to get the rc 6.5 but i was worried about haveing to replace alot of stuff so i was thinking rc 4.5 with coil spacers in the front what do yall think?

xjjeepthing

Proabbly have to trim the fenders with 4.5"

LoganJeep

even with the coil spacers in the front i just dont want problems with the 6.5 lift

Tucker

i have the rc 4.5 and no spacers and my 33 fit fine you just have to trim you fenders.

whowey

You have a 2000 with the smaller wheel openings. You are going to have to trim anyways, no matter the lift.



That is 33"s on a 3.5 inch lift. The rubbed mercilessly on even tiny inclines.

JakeWI

you could always go with 32" tires. either way i would think about going 10.5 wide. i have 4.5" RC and i only run 31's. i do it so i dont have to trim and i can get full turn with no rub. but there is room for larger.

kmanxj5050

x2 i had rusty's 4.5", trimmed fenders and i came bouncin out of a mud hole with sway bar unhooked and put the tire into the fender. Go 6.5

jeeptilldeath

you should be able to fit them... minor triming but than all you need is a sawzall if you go with the 6.5 you will need the sye and extended brake lines. IM goin with the 4.5 and 35's... so im gonna be trimin.

xjjeepthing

If you go 4.5" get a set 32" tires on 4" backspaced wheels and bumpstop it corectly you shouldn't have any issues.

vbxjeeper

I run the RC 4.5 and 33x13.50 LTBs. they rub but I have only done minor trimming. my wheels are 4'' BS.

COSXJFAN

Bumpstops and cut off wheels, and you're in!!