I need some opinions
#1
Newbie
Thread Starter
Join Date: Jul 2013
Location: North West Indiana
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Grand Cherokee
Engine: 4.0 Liter IL6
I need some opinions
This is my first jeep and I have been making mods here and there. I've got some issues that need attention and could use some experienced jeep owners opinions.
Last edited by DustinLeeZJ; 08-17-2013 at 01:03 AM.
#2
Newbie
Thread Starter
Join Date: Jul 2013
Location: North West Indiana
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1995
Model: Grand Cherokee
Engine: 4.0 Liter IL6
Engine Block:
I have the head off because it had a failing head gasket. I have the cylinders all cleaned up and there is no relevant damage or scoring of the cylinder. My main concern is the chip in the piston.
Transfer Case:
I'm not sure whats going on there but after some quick research I believe that is called the oil slinger that is in the incorrect position. I just moved it back over the t-case output.
Rear Diff/Axle:
I think I have a leaking pinion seal, as well as a terrible howling whining sound that gets high pitched the faster its going.. Could be coming from anywhere in the drive train. I did replace the U-joints the pinion angle is terrible.
Front Drive Shaft:
I'm not sure what I have here but the part that the zirk is on was moved away from the shaft it is supposed to be snug to. I pushed it back up onto the shaft and greased it.
I have the head off because it had a failing head gasket. I have the cylinders all cleaned up and there is no relevant damage or scoring of the cylinder. My main concern is the chip in the piston.
Transfer Case:
I'm not sure whats going on there but after some quick research I believe that is called the oil slinger that is in the incorrect position. I just moved it back over the t-case output.
Rear Diff/Axle:
I think I have a leaking pinion seal, as well as a terrible howling whining sound that gets high pitched the faster its going.. Could be coming from anywhere in the drive train. I did replace the U-joints the pinion angle is terrible.
Front Drive Shaft:
I'm not sure what I have here but the part that the zirk is on was moved away from the shaft it is supposed to be snug to. I pushed it back up onto the shaft and greased it.
Last edited by DustinLeeZJ; 08-17-2013 at 01:06 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Zach Smith
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
11
09-26-2015 03:24 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)