i have a bit of a problem
 

i just installed my new sye now the jeep will not shift into 2wd and everything spins in neutral i followed the instructions but idk what the hell is going on

did you check you linkage?

i never touched the linkage

taking the linkage off and shifting it from the transfer case it wont go past 4 high

Did you shift it into 4wd before taking transfercase apart..I believe my friend had the same problem and I believe you have to put it in 4wd before taken it apart...but I could be wrong

yes it was in 4 high during the build

not trying to beaa smart a no extra parts right:blush:

these people have a break down if you look your tc up http://http://www.jeep4x4center.com/...atio-chart.htm

Did you grind enough off the shaft that comes back towards the nose cone? U can take the plug out and see if it is hitting there. if so take the rear cone off and grind some more down.
Even tho u built it in 4hi it may not be quit enough to clear

:thumbup1:
yep they have a build on extrenme 4x4 about cuttin the shaft to allow it to slide in the hew rear case power blocktv.com

haha, it happened to me. it was enought to clear with that plug out(barely) but with the plug in it wouldnt go past 4hi. $hi is as far back as that shaft goes then moves back foward a bit for 4lo

ok so i did grind off a bit of the shift rod and that was the problem it shift so nice and smooth now it very good ya hehe

now go drive it like you stole it:thumbup: