Help with regulator removal
#1
CF Veteran
Thread Starter
Join Date: Oct 2009
Location: Parrish
Posts: 1,487
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Comanche
Engine: 4.0
Help with regulator removal
Changing the manual window regulator in my 94. I am trying to remove the bolt that removes the window from the regulator but its just spinning. How am I supposed to do that without replaceing the window. Any help would be greatly appreciated.
The reason why I am changing it is it only goes down halfway then gets stuck and you have to pull the window with your hand while cranking it to get it back up.
The reason why I am changing it is it only goes down halfway then gets stuck and you have to pull the window with your hand while cranking it to get it back up.
#3
CF Veteran
Thread Starter
Join Date: Oct 2009
Location: Parrish
Posts: 1,487
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Comanche
Engine: 4.0
Yes if I roll the window down a bit. What I believe are the door crush beams are in the way higher up. What should I hold the retainer with???
#5
CF Veteran
Thread Starter
Join Date: Oct 2009
Location: Parrish
Posts: 1,487
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1989
Model: Comanche
Engine: 4.0
I ended up getting it. Instead of clamping it I found there was a small manufacturing hole in the retaining plastic and I used vise grips holding a allen wrench to keep that plastic piece from moving. Worked like a charm. I am now jealous of how smoothly the passenger side rolls up and down. The drivers side works fine but it gets harder towards the bottom.
Thread
Thread Starter
Forum
Replies
Last Post
carverdave
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
02-06-2019 08:55 AM
little smathers
Modified XJ Cherokee Tech
0
09-20-2015 03:32 PM
WolfeMan
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
2
09-14-2015 06:42 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)