grease job details
#1
Banned
Thread Starter
Join Date: Oct 2016
Posts: 1,553
Likes: 0
Received 4 Likes
on
4 Posts
Year: 2000 and 1998
Model: Cherokee
Engine: 4.0
grease job details
just read this from "moparado"
how many?. been wanting to ask. i found 5. ? miss any, ? want to do again sat.
what about front axel u joints?, no zerks?, last forever! ?
Grease all zerk fittings too.
what about front axel u joints?, no zerks?, last forever! ?
#3
Banned
Thread Starter
Join Date: Oct 2016
Posts: 1,553
Likes: 0
Received 4 Likes
on
4 Posts
Year: 2000 and 1998
Model: Cherokee
Engine: 4.0
i went there and found some bs sites.
and here i thought the forum would be better equiped.
ill crawl under and have a good look sat. report back later.
thanks
and here i thought the forum would be better equiped.
ill crawl under and have a good look sat. report back later.
thanks
#4
CF Veteran
Join Date: Oct 2013
Location: Tarpon Springs, FL / Denver, CO
Posts: 2,097
Likes: 0
Received 8 Likes
on
7 Posts
Year: '98
Engine: 4.0 I6
Pretty standard.
Front steering tie-rod ends
Front driveshaft slip yoke, check and see if your u-joints have greasepoints as well (may need to remove the shaft to get at the greasepoint though)
Aftermarket control arms, track-bars, etc
Crawling under there and looking is probably easiest. The only hard to find ones are the front driveshaft grease fitting (it is right where the slip splines are), and the u-joints if they are greasable (factory were not in the case of my 98 XJ)
Front steering tie-rod ends
Front driveshaft slip yoke, check and see if your u-joints have greasepoints as well (may need to remove the shaft to get at the greasepoint though)
Aftermarket control arms, track-bars, etc
Crawling under there and looking is probably easiest. The only hard to find ones are the front driveshaft grease fitting (it is right where the slip splines are), and the u-joints if they are greasable (factory were not in the case of my 98 XJ)
Last edited by investinwaffles; 06-10-2017 at 12:06 AM.