Heather <3 Mudd

Last night when I was driving down the highway (after a little off-roading) my car just completely shut down and would not start back up. It turns over but just will not start.
I ran diagnostics on it and it showed code P0201 through P0206
This says there is a problem controlling the fuel injectors on open cylinder 1-6.
How do you fix this and what does it mean exactly. I believe it is something electrical (which is not my specialty) that controls all of the injectors. Mainly because all 6 are having issues at one time.

Help?
Thank you

cpnwrench

fuel pressure regulator...

should be on or near fuel rail near injectors....see if maybe it got plugged or jostled when you went wheeling...

just a thought


cpnwrench

The Rooster

I would so clean out all the mud... maybe mud got in the plugs? or connectors..

xjfanatic

Hey sorry I couldn't help any more yesterday... All the wires were connected and there was barely any mud up in the engine compartment... Does anyone know if there are wires related to the injectors that run under the vehicle? I also try to avoid electronics when it come to jeeps

Heather <3 Mudd

Thanks for all your help yesterday Ethan! My dad said it sounds like it could be the crank sensor. so im going to check that, hopefully thats it because i have a few spares lol

freegdr

injector pulse is controled by the cam position sensor in dist look in to that

freegdr

http://www.jeep4x4center.com/knowled...ex.htm#service

Heather <3 Mudd

Thanks I will try that

redmuck

hey heather,you say your in milford, is that indiana?

Heather <3 Mudd

nope michigan