So I managed to grab a set of bushwacker pocket flares for my two door for a stupid good deal used (40bones) but there is no hardware. Does anybody know the hardware I need? I know there is some fairly large spacers needed, and self tapping screws just not sure on the size. Someone please help!

 

They run about $30 new I can get them for you though.

 

Im looking to pick them up at a local hard ware store so I can get the flares on as I got a second fix it ticket. Any ideas on the sizes?

 

Anyone? Length of the self tapping screws is the main thing im looking for..

 

ok the screws are 1 1/4" long on the thread and they are not self tapping. you are required to drill then screw them in. i believe the spacer is like 3/4'" thick and it is made out of rubber. here is a link to the install instructions:

http://www.bushwacker.com/instructio...D,COMANCHE.pdf

hope this helps. but the screws should be at least 1 1/4" long. you also have to cut your fenders, just read the instructions and you should be golden

 

Thanks alot for the help! I was particularly looking for the spacer thickness and the length of the screws.

Thank you trans am.