I snapped the wire linking the CPS to its connecter. How screwed am I?
#1
Seasoned Member
Thread Starter
Join Date: Dec 2016
Location: Lawrence ****ing Kansas
Posts: 391
Likes: 0
Received 6 Likes
on
6 Posts
Year: 1997
Model: Cherokee
Engine: 4.0
I snapped the wire linking the CPS to its connecter. How screwed am I?
I removed the engine head and, while I had it disconnected it from the wiring harness, I accidently left the CPS's electrical connector attached to the head. And when a friend and I pulled the head off, I didn't see or feel it and it just broke the wire
Here's the worst part though, the wire broke at the exact point where it exits the bell housing.
Is this going to be a big problem? Or can I repair it?
Here's the worst part though, the wire broke at the exact point where it exits the bell housing.
Is this going to be a big problem? Or can I repair it?
#3
Seasoned Member
Thread Starter
Join Date: Dec 2016
Location: Lawrence ****ing Kansas
Posts: 391
Likes: 0
Received 6 Likes
on
6 Posts
Year: 1997
Model: Cherokee
Engine: 4.0
nevermind, it was snapped at the CPS itself (I thought maybe the sensor was inside the bellhousing, and there was so much grease you couldn't see anything)
I was able to remove the CPS, it wasn't very hard with the head removed and with a good, stubby 3/8" ratchet. Guess I need a new CPS though
I was able to remove the CPS, it wasn't very hard with the head removed and with a good, stubby 3/8" ratchet. Guess I need a new CPS though
Thread
Thread Starter
Forum
Replies
Last Post
BimmerJeeper
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
37
09-10-2017 12:07 PM
Mikeythrash
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
14
01-04-2014 10:52 PM
White Elephant
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
6
07-10-2012 05:55 PM
Soaper
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
8
10-24-2011 02:55 AM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)