Access through Firewall?
#1
CF Veteran
Thread Starter
Join Date: Oct 2008
Location: Wyo
Posts: 1,052
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Access through Firewall?
Hey all.
Where is a good access point in the firewall to run a power supply to my amp? I'd prefer to find one on the passenger's side since that is the battery side.
I looked all over earlier, but it was cold, so I didn't want to spend too much time looking.
s
Where is a good access point in the firewall to run a power supply to my amp? I'd prefer to find one on the passenger's side since that is the battery side.
I looked all over earlier, but it was cold, so I didn't want to spend too much time looking.
s
#2
Member
Join Date: Dec 2008
Location: Winterpeg,Canada
Posts: 201
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0l
pass side, not sure. driver side has a main harness coming thru, i am going too run wiring thru there for the lights i am going to install. to the left of the steering column.
#3
Member
Join Date: Oct 2008
Location: Stillwater, NJ
Posts: 197
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1994
Model: Cherokee
Engine: 4.0 L AMC 242 High Output
There is one, pop your hood and look about in line with the passenger side of the console on the firewall. Theres a little oval rubber plug, you can pop that plug off, and drop a wire down into your floor of the passenger seat. What i did was cut a little X in the plug and put the wires through, and then reseated the plug.
#4
Seasoned Member
Join Date: Jan 2009
Location: FLORIDA
Posts: 359
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: I-6
There is one, pop your hood and look about in line with the passenger side of the console on the firewall. Theres a little oval rubber plug, you can pop that plug off, and drop a wire down into your floor of the passenger seat. What i did was cut a little X in the plug and put the wires through, and then reseated the plug.
#5
CF Veteran
Join Date: Nov 2008
Location: Eugene, OR
Posts: 1,251
Likes: 0
Received 0 Likes
on
0 Posts
Year: 01
Model: Cherokee
Engine: 4.0L I6
i went through the one on the D side. down by the pedals, its a rubber piece, i just cut a small hole in it and ran my power wire through there. was easy.
#6
CF Veteran
Thread Starter
Join Date: Oct 2008
Location: Wyo
Posts: 1,052
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
There is one, pop your hood and look about in line with the passenger side of the console on the firewall. Theres a little oval rubber plug, you can pop that plug off, and drop a wire down into your floor of the passenger seat. What i did was cut a little X in the plug and put the wires through, and then reseated the plug.
s
Thread
Thread Starter
Forum
Replies
Last Post
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
10-23-2018 04:21 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)