89PBR96

I'm takin my front doors off how do i do away with the interior light bein on i got one door off so far and can't locate the fuse for the lights besides that it says it's with the radio ??

REWSTER

i know i have seen something for wranglers that holds the thing down i will have to find it i think quadrtec

Schmoozer

unscrew the little pressure switch in the door and unplug it, its the first thing this guy does in his write-up: http://www.jeepforum.com/forum/showthread.php?t=408138

and yeah, i've wondered about those, will those work on a Cherokee: http://www.quadratec.com/products/13029_100.htm

REWSTER

here you go

http://www.quadratec.com/products/13029_100.htm



edit: ya beat me to it i think i have read they work

Schmoozer

ha ha, but yeah that would make sense that they're the same size, i guess quadratec just can say it fits a stock Cherokee.

prerunner1982

If it was me I would wire a switch to disable the door switches. I would end up misplacing the little clips from Quadratec, can't misplace a switch mounted to the dash.

tomcarey88

just take that little butten thng off with a wrench,what u using for a mirror.i used a atv mirror an mounted it on that bracket were that bar goes that prevents the door from swinging

Mullins_j

I'm with prerunner...... I'm doing mine this weekend, and I'm going to place a toggle switch on the dash, to kill them. That way when you have the doors off, you you just hit the toggle, and all is good my friend. I'd probably loose those damn clips too. If you look in the back of a hynes manual, it has the wire diagram.

Schmoozer

If you take out one of the switches will it disable it for all doors or is there a circuit for each door? (I don't have a hynes manual.) I just seems like it would be difficult to wire a switch if it were 4 different circuits without running wires from the dome lamp itself to use for the switch.

Mullins_j

By looking at the wire diagram there is one single yellow ( color depending on year) that comes off the headlight switch. I'm going to tie in right there, as that one control's the interior lights. Should be easier. I'll do it this weekend, and try and do some pix to post on here.

89PBR96

Thanks guys really helpful

89PBR96

That helped a bunch on how to get them pins out also another guys

Mullins_j

this is a good one also......

http://www.jeepforum.com/forum/showthread.php?t=444398

Phil99

I have a question on the doorless write up that the one guy did on another forum, what did he do with all the wire and the harnes? And if you want to put them back on what do you do about that pin that you have to cut out?

Schmoozer

I'm not sure what write up you read but the one I posted tells you.

The wiring is all disconnected under the kick panel.

For the pins, I believe people have had luck with 5/16" bolts, but the two holes (for a 97+) are different diameters because one has bushings.