97 p171 problem
97 xj 4.0l new exhaust header &o2 sensor.previous header had a crack at the collector.starts fine & runs ok until it goes into closed loop. then can hear a slight change in intake air as IAC changes. vacuum falls from 17 in. to 13 in., runs rough then shows 171 code.runs extremely rich.have checked for vacuum leaks including plugging vacuum port that goes to charcoal canister and other places. new iac & tps.next step is to blow propane around manifold to see if anything changes.also, O2 sensor volts hover around .22 volts with slight increase as throttle in goosed. help please
|
Originally Posted by wa9yor68
(Post 2993323)
97 xj 4.0l new exhaust header &o2 sensor.previous header had a crack at the collector.starts fine & runs ok until it goes into closed loop. then can hear a slight change in intake air as IAC changes. vacuum falls from 17 in. to 13 in., runs rough then shows 171 code.runs extremely rich.have checked for vacuum leaks including plugging vacuum port that goes to charcoal canister and other places. new iac & tps.next step is to blow propane around manifold to see if anything changes.also, O2 sensor volts hover around .22 volts with slight increase as throttle in goosed. help please
P0171-1/1 FUEL SYSTEM LEAN Here's some possible causes: INTERMITTENT CONDITION RESTRICTED FUEL SUPPLY LINE FUEL PUMP INLET STRAINER PLUGGED FUEL PUMP MODULE O2 SENSOR O2 SENSOR SIGNAL CIRCUIT SHORTED TO GROUND O2 SENSOR HEATER OPERATION TPS VOLTAGE GREATER THAN 0.92 VOLTS WITH THROTTLE CLOSED TP SENSOR SWEEP MAP SENSOR OPERATION ECT SENSOR OPERATION ENGINE MECHANICAL PROBLEM FUEL FILTER/PRESSURE REGULATOR (HIGH) PCM Is your fuel pump pressure okay? Don't have the PDC layout available right now, but you could check the mini fuses one at a time to see if you have a blown O2S heaters fuse. Check the upstream O2S wiring as it passes over the intake manifold for chafing through the loom and to the wiring within. Check the downstream O2S wiring for being ate up by the driveshaft. |
black exhaust & can tell by smell, also burns eyes- wiring to o2 sensor is ok, already checked at plug-apparently o2 sensor is sending lean sig to cpu & cpu enriches fuel to compensate- gotta get a fuel pressure gauge tomorrow& check that-the o2 sensor i used is a ngk 23151,i believe it's the right one-sure has me stumped-maybe the cpu? because it runs good in open loop but no good as soon as all the sensors come into play
|
All times are GMT -5. The time now is 02:37 AM. |
© 2024 MH Sub I, LLC dba Internet Brands