92 with 98 manual transmission swap
Thread Starter
Newbie
Joined: Jan 2012
Posts: 24
Likes: 1
Model: Cherokee
92 with 98 manual transmission swap
I have picked up a 1998 Manual trans from a 4.0 4x4 Sport Cherokee and I want to install it my 4x4 1992 Larado with 4.0. My only reason for doing this is so that I get a way from the internal clutch slave cylinder. I am hoping that it will fit right in there. If you have any information I appreciate it. By the way both jeeps have the 231 transfer case also. Thank you
Junior Member
Joined: May 2008
Posts: 15,016
Likes: 11
From: +34° 25' 35.67", -81° 21' 12.04"
Year: 1993
Engine: 4.0
Should bolt right up.
If not, you can take the slave, slave master, bearing retainer plate, clutch, throwout bearing and bell housing and put it all on your old transmission and it'll go right back in like it came out.
If not, you can take the slave, slave master, bearing retainer plate, clutch, throwout bearing and bell housing and put it all on your old transmission and it'll go right back in like it came out.
Thread
Thread Starter
Forum
Replies
Last Post
Programbo
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
23
May 23, 2024 07:20 AM
15XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
Sep 10, 2015 11:17 PM
Azzy
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
0
Sep 8, 2015 10:49 PM
Vegas101
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
0
Sep 4, 2015 11:52 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)