#1&2 injectors not firing
#1
Junior Member
Thread Starter
Join Date: Feb 2018
Location: Edgewood nm
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee (XJ)
Engine: 4.0
#1&2 injectors not firing
2000 sport.
Any ideas why 2 injectors wouldn’t be firing? My thoughts are pcm. Spark plugs are good. I swapped the 2 with another 2 that are working properly. I also swapped around injectors and it’s still the same 2. It was just #2 and then I plugged 1 connector to 2 and now it’s 1 and 2.
Any ideas why 2 injectors wouldn’t be firing? My thoughts are pcm. Spark plugs are good. I swapped the 2 with another 2 that are working properly. I also swapped around injectors and it’s still the same 2. It was just #2 and then I plugged 1 connector to 2 and now it’s 1 and 2.
#2
CF Veteran
Join Date: Dec 2015
Location: PA
Posts: 3,038
Likes: 0
Received 333 Likes
on
277 Posts
Year: 1997
Model: Cherokee
Engine: 4.0L
Disconnect the battery, and check the injector and PCM connectors for any corrosion, and then test the wiring for each injector, for an open circuit, using a multimeter.
#3
Junior Member
Thread Starter
Join Date: Feb 2018
Location: Edgewood nm
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee (XJ)
Engine: 4.0
1 and 2 connectors were pretty tore up at the injector itself so I replaced them. At 1 I have 0v across the two terminals and 13.8 to ground on the energized half. At 2 I have 13.8 across both terminals. 3,4,5 and 6 I have .08v across the terminals and 13.8 to ground on the energized half. Across all 6 between the connector and pcm I have continuity so the wire itself is fine. I did put another 2000 pcm on but it was a 634af not a 635af like mine it wouldn’t stay running but for the few seconds that it would it sounded great and seemed to be firing on all 6. I didn’t have enough time to check for sure but I’m pretty sure it was
#4
Junior Member
Thread Starter
Join Date: Feb 2018
Location: Edgewood nm
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2000
Model: Cherokee (XJ)
Engine: 4.0
I was finally able to get my scanner and hook it up. I’m getting code p1694 and p0201/02. I cleared the codes but didn’t change anything. I also tried resetting the computer with the positive to ground for 30 second, key on, light on, lights off, key off method. Still the same I have a new pcm coming so hopefully that’s the problem
Thread
Thread Starter
Forum
Replies
Last Post
88witha96
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
44
09-20-2014 07:27 PM
mattphillips90
Engines/Tranny/T-Case
2
04-23-2014 09:27 PM
benratt
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
39
09-19-2013 06:03 AM
DrEmAn1313
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
9
09-10-2009 11:35 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)