Something New, Safety Misalignment!
Not Safety Washers & not Standard High Misalignment.
I was looking to add Safety Washers to our line up but something kept bugging me. Wouldn’t the mating surface between the High Misalignment and the Safety Washer add more stress to something you are trying to make more safe? Misalignment goes inside the bore of the rod end to remove the stress but a traditional Safety Washer goes on top of the stack and adds an unresolved join right next to the bolt end. http://www.ruffstuffspecialties.com/...ment%20004.jpg What I came up with doesn’t seem like it should be revolutionary or anything but I couldn’t find another like it so here goes. I combined the Safety Washer with the High Misalignment to eliminate the need for a separate piece. I would only use them where needed because they cost a bit more than a traditional High Misalinment because we have to start with a substantially larger Stainless Rod and Stainless isn’t cheap. http://www.ruffstuffspecialties.com/...ment%20002.jpg Another benefit is while eliminating the gap between the safety washer, you shorten the bolt overall length which lessens the leverage on the bolt. |
Something new, Safety Misalignment!
When doing a heim steering kit.. This is what you need !!!
|
Small but very important!
|
Trust me, these are good to have when you need them!
|
Be sure to checkout our new products section for periodic updates!
|
All times are GMT -5. The time now is 08:27 PM. |
© 2024 MH Sub I, LLC dba Internet Brands