99 GC LED interior question
#1
Newbie
Thread Starter
Join Date: Oct 2016
Location: Virginia Beach, VA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Grand Cherokee
Engine: 4.0 inline 6
99 GC LED interior question
I get different answers everywhere I search, such as adding a 6ohm resistor to the trunk light or adding 500 something ohm to each light, etc. Answers seem to be all over the place for my issue, but basically I swapped all interior lights to LED's and they all stay on (minus the ones on the front doors, they seem to function normally). They all stay on if youre driving. If you get out and lock car, the door ones go out as I said but all the rest stay lit for 8 minutes until the jeep kicks in to cut off all interior electronics. So... Ive heard i need a resistor but answers are everywhere. Can anyone say with 100 percent CERTAINTY what to get for this issue. Not a fun thing driving at night with all my interior lights blaring at me LOL
#2
Newbie
Thread Starter
Join Date: Oct 2016
Location: Virginia Beach, VA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Grand Cherokee
Engine: 4.0 inline 6
Okay so I didnt want lights on while driving inside... so took out all damn LEDs and put my reg's in and they wouldnt go off after reinstalling them! they were acting like the LEDs... WTH ??? Took em all out so i can drive and will mess with them tomorrow, but does anyone have any clue whats goin on???? maybe ecu or whatever weirded out for a bit?
#3
Member
I did an LED swap on my interior. No issues here. What bulbs did you use?
Just to make sure... is your interior light dimmer set to always on?
Just to make sure... is your interior light dimmer set to always on?