Mark this thread as Unsold
FS[PacSouthWest]: SmittyBilt XRC Front Winch Bumper + Rear Bumper with Swing Out
#1
Member
Thread Starter
Join Date: Jul 2015
Location: Tehachapi CA
Posts: 156
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1996
Model: Cherokee
Engine: 4.0 HO
SmittyBilt XRC Front Winch Bumper + Rear Bumper with Swing Out
I have had these for less than a year and do not like the additional weight. I am going to remove and sell. Plan on making my own tube style bumpers to reduce the weight. Front bumper is for winch and rear bumper has the swing out tire / jerry can / jack holder. Both have some finish scrapes on bottom areas but overall look good. The swing out on the rear bumper would not stay latched with the linkage going from the release handle to the latch so I removed the linkage and it stays now. I release it by pressing the release latch directly. You can put linkage back and try to figure out why it was coming loose but I was happy with the way it operates this way.
Going to sell as a set for $800 plus your front stock bumper. Will accept cash or PayPal Gift.
The only partial trade consideration would be a PowerTrax No-Slip to fit the front Dana 30.
Going to sell as a set for $800 plus your front stock bumper. Will accept cash or PayPal Gift.
The only partial trade consideration would be a PowerTrax No-Slip to fit the front Dana 30.
Last edited by RickJames Bish; 07-11-2016 at 09:04 AM.
#3
Newbie
Join Date: Mar 2016
Posts: 6
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0
I am looking to install bumpers similar to this. I read your threat about them being to heavy. Would you mind sharing your issues with me about the weight as there are very few XJ sets out there anymore short of having custom ones made by a welder. Thank you in advance for any insight you have.
Thread
Thread Starter
Forum
Replies
Last Post
SouthernPine766
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
7
04-13-2016 05:14 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)