Mark this thread as Unsold
FS[MidWest]: 1992 XJ D30 and Chry 8 3/4. 3:55 ratio
04-10-2015, 09:43 AM
#1
Senior Member
Thread Starter
Join Date: Sep 2008
Location: Sioux Falls, SD
Posts: 897
Likes: 0
Received 12 Likes
on
9 Posts
Year: 1999
Model: Cherokee(XJ)
Engine: 4.0L
1992 XJ D30 and Chry 8 3/4. 3:55 ratio
I swapped a lower set of axles into my 1992 Cherokee (XJ) and I have the original axles available.
Front is the usual Dana 30 (NON Disco) and rear is Chrysler 8 3/4. Both are 3:55 ratio. Hub bearings were replaced on front about 15K miles ago. Both axles have 230K miles on them. No leaks but could use a seal rebuild I'm sure.
Will include a box of brake hardware for rear. DRUM brakes. 9 Inch.
Left shock stud snapped on rear axle. Front left caliper bolt needs to be drilled out of knuckle.
$150 for both. Located in Sioux Falls, SD.
Front is the usual Dana 30 (NON Disco) and rear is Chrysler 8 3/4. Both are 3:55 ratio. Hub bearings were replaced on front about 15K miles ago. Both axles have 230K miles on them. No leaks but could use a seal rebuild I'm sure.
Will include a box of brake hardware for rear. DRUM brakes. 9 Inch.
Left shock stud snapped on rear axle. Front left caliper bolt needs to be drilled out of knuckle.
$150 for both. Located in Sioux Falls, SD.
Last edited by diskman; 04-17-2015 at 02:15 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Lightning_19k
Modified XJ Cherokee Tech
14
10-03-2015 09:52 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)