Jeepxj1234

Ok so I bought some new re super ride fixed lower control arms for my xj which has a 4" lift and have a few questions about the install:
What I know- I need to pb blast the bolts every other day or so a week prior to putting them in, I need to support the axle and make sure it doesn't move out of place when putting them in, and I should do one side at a time.
What I would like to know- how to and if I need to grease them, how to keep the cam bolts straight or something (?), and how to install them without having to go get an allignment.
Thanks for the help

opie1988

http://www.myjeepxj.com/cherokee-rep...r-control-arms

93gc40

No cam bolts to worry about on a XJ.. If you change the arms you MUST get an alignment, since you are going to be changing it with the new arms and lift. There many write-up on DIY alignment, it is very easy and only requires 2 wrenches and a tape measure. Yes you need to grease them, the arms should have fittings. You are putting longer arms on so you will have to move the axle to mount them, Ratchet straps come in handy. Easier to do with wheels mounted on the axel so you can roll it around. Torque all bolts you loosen after you remove the jacks.

Jeepxj1234

Yeah I found that too but it doesn't really tell you how to install it.

Jeepxj1234

Ok cool but couple questions: so if I do my own diy alignment then I won't have to take it to a shop? How exactly do you grease them and what do you use to grease them? And how do you move the axle with the straps or the wheels? Thanks

Jeepxj1234

Ok so I think I've decided to take it to a shop to get it aligned. Probably better to get it done right. So greasing them? What do I use and how do I do it? And what is the easiest way to pull the axle forward?

Bossokee

Use a grease gun and pump grease into the small fittings visible on the joint. As for the installation you can use ratchet straps or a come-along to pull it into place, a jack to hold it up, or just muscle it with some buddies

Jeepxj1234

Ok cool thanks. But only one side at a time though right?

Bossokee

Yeah, it's not too hard with a couple extra hands

Jeepxj1234

Gotcha. Thanks for the tips

Ian96XJ

Reviving so I don't have to make a new post.

So what do you need to use the ratchet straps for? What do you ratchet to what? I'm replacing a stock LCA to one for a 3" lift. Thanks.

Jeepxj1234

Ok so when you take your old lower control arms off (I did mine 1 at a time) the axle will be too close to the frame mount to fit the new longer lower so you can connect the straps to the axle and like a tree or something to get the axle in place and hold it while you instal the new lca

storm101

The strap is to pull the axle back into place, when you remove the arms the axle moves away from the arms so upon installation you'll be pulling the axle into the arms so you can bolt them up.

When you swap them just make sure you have one or two handy, you'll understand better once you see it.

Ian96XJ

Thanks, that's kinda what I thought. I'm also assuming it won't take TOO much to move the axle. I don't have a tree handy, but I think I can hook to a tow hitch of another vehicle to get the same result.

If it's up on a lift, does it make it easier or harder?

Jeepxj1234

I used another vehicle to pull it forward too actually but idk about the lift.