Ford 8.8 Eaton Elocker install
#1
Newbie
Thread Starter
Join Date: Jan 2015
Location: Tucson, AZ
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1990
Model: Cherokee
Engine: 4.0L inline 6
Ford 8.8 Eaton Elocker install
Got a Ford 8.8 out the junk yard from a 97 Explorer and Flange adapter will be swapping it into my xj . Doing 4.88 G2 gears with Eaton Elocker, Iro Swap kit with steel braided brake lines. My question is can I run the wires for the Elocker through the speed sensor hole? 1) wont be using sensor 2) the Eaton elocker the wires are on the ring side of carrier same as sensor.3) tone ring wont be installed on new carrier. I was figuring that I could thread the sensor hole, put a pipe plug in and drill required hole through it to route wires. haven't had luck googling to see if this has been done yet. advise and help on this with pics would be greatly appreciated
Thread
Thread Starter
Forum
Replies
Last Post
NM-XJ
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
18
10-23-2018 04:21 PM
98JGC826
Stock Grand Cherokee Tech. All ZJ/WJ/WK Non-modified/stock questions go here!
2
09-03-2016 08:10 PM
Blackxj51
Stock XJ Cherokee Tech. All XJ Non-modified/stock questions go here
22
09-13-2015 06:06 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)