Flag mounts
04-27-2016, 05:17 PM
#2
CF Veteran
Join Date: Feb 2015
Location: North Carolina
Posts: 1,528
Likes: 0
Received 2 Likes
on
2 Posts
Year: 1993
Model: Cherokee
Engine: 4.0
I made a homemade hitch pole. I also saw a guy the other day who has just put one of the little metal flag pole brackets on his bumper. I wouldn't think it would hold up very well but with as often as I see it I guess it does.
04-28-2016, 08:23 AM
#3
Newbie
Join Date: Mar 2016
Location: Indiana
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
I have a homemade one that's just a metal pipe welded to a standard 2 inch hitch. then i have a flag on a pvc pipe with screw to keep it from sliding down too much. for $25 you can't beat it.
04-28-2016, 11:53 AM
#6
CF Veteran
Join Date: Oct 2013
Location: Greenville, SC
Posts: 5,920
Likes: 0
Received 190 Likes
on
165 Posts
Year: 1999
Model: Cherokee(XJ)
Engine: 4.0
I make them and sell them. 2" square tube, 1 1/2 round tube about a foot of each, 1" Pvc pipe, 1/4 pin and a couple holes for height adjustment. Cut either a fitting or the bulge end of conduit for ziptie retainers. Cost probably ~$10 if that. 
Last edited by SatiricalHen; 04-28-2016 at 11:56 AM.
04-28-2016, 12:41 PM
#7
CF Veteran
Join Date: Sep 2013
Location: Albuquerque, NM
Posts: 2,820
Likes: 0
Received 4 Likes
on
4 Posts
Year: 1999
Model: Cherokee
Engine: 4.0
I used self tappers and the mount the flag came with(for a wall). work perfectly, and my bumper was bent enough to where it points straight up.
Trending Topics
05-01-2016, 02:03 AM
#8
Junior Member
Thread Starter
Join Date: Nov 2015
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
if I only had a hitch receiver
05-07-2016, 10:42 PM
#10
Junior Member
Thread Starter
Join Date: Nov 2015
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
05-08-2016, 06:54 PM
#13
CF Veteran
Join Date: Oct 2013
Location: Greenville, SC
Posts: 5,920
Likes: 0
Received 190 Likes
on
165 Posts
Year: 1999
Model: Cherokee(XJ)
Engine: 4.0
I have ares fab bumpers, I like them, I slightly tweaked the rear bumper pulling someone out though. He had a fully loaded trailer, stuck on the side of the road and I was pulling with my 6" drop because I was too lazy to pull a d ring off. I had it in 4 low spinning all 4 on pavement. Here's some pictures of the bumper 
