dual battery set up in a cherokee?
#1
Senior Member
Thread Starter
Join Date: Mar 2011
Location: San Antonio, TX
Posts: 643
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0L
dual battery set up in a cherokee?
So with running my winch, off road lights, upgraded head lights, sub, amp, cb radio,ect....I am thinking of doing a dual battery set up.
This is the thing i will be using to relocate the air filter.
http://www.quadratec.com/products/17006_7101_07.htm
Then if it is possible using these on in stock battery location and one where the air box use to be.
http://www.ballisticfabrication.com/...x-_p_1673.html
Then as far as conecting the two battery not sure on if i just run a positive and negitive from 1 to other or if i need a special set up to do this any detailed info would be great.
This is the thing i will be using to relocate the air filter.
http://www.quadratec.com/products/17006_7101_07.htm
Then if it is possible using these on in stock battery location and one where the air box use to be.
http://www.ballisticfabrication.com/...x-_p_1673.html
Then as far as conecting the two battery not sure on if i just run a positive and negitive from 1 to other or if i need a special set up to do this any detailed info would be great.
#2
Senior Member
Join Date: Jan 2011
Location: Thornton, CO
Posts: 859
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1998
Model: Cherokee
Engine: 4.0
I think it would be in your best interest to look into the Painless wiring dual battery setup. Gives you much better control of your electrical system as a whole
#3
Senior Member
Thread Starter
Join Date: Mar 2011
Location: San Antonio, TX
Posts: 643
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0L
Would i need a to get new altinator? because right now i just bought one from autozone for the stock cherokee.
I am trying to figure out if i am in need of two batterys, I do go wheeling at night quite a bit i dont want to be out in the middle of no where with all my lights on winching and have my battery die or make my alt over work its self.
I am trying to figure out if i am in need of two batterys, I do go wheeling at night quite a bit i dont want to be out in the middle of no where with all my lights on winching and have my battery die or make my alt over work its self.
Last edited by chrisquested; 02-09-2012 at 08:19 PM.
#4
From what I have read on here, your best bet would be the painless wiring set up, along with a higher amp alternator...I believe one I saw mentioned to me was in the 130's, but I don't recall exact numbers. I think that would clear up the possibility of a dead battery...one more suggestion, especially if you do a lot of part road...optima battery, warranty sucks cuz most auto stores don't have a pro-rate past the free replacement, but you stand a far less chance of collapsing a cell in a gel cell battery...
#5
Senior Member
Thread Starter
Join Date: Mar 2011
Location: San Antonio, TX
Posts: 643
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0L
From what I have read on here, your best bet would be the painless wiring set up, along with a higher amp alternator...I believe one I saw mentioned to me was in the 130's, but I don't recall exact numbers. I think that would clear up the possibility of a dead battery...one more suggestion, especially if you do a lot of part road...optima battery, warranty sucks cuz most auto stores don't have a pro-rate past the free replacement, but you stand a far less chance of collapsing a cell in a gel cell battery...
#6
Seasoned Member
Join Date: Mar 2011
Location: Richmond
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
Year: 98
Model: Cherokee
Engine: 4.0
I can vouch for the Painless power manager setup. It works pretty well, and is auto sensing and does the work for you. It includes cables to hook everything up, just keep the power manager unit near the front of the engine bay or you won't have enough cable to reach... Easily fixed with 10 bucks of cable from Lowes.
I already had a Mean Green alt(200amp), so didn't need anything there.
I went with a Wrangler NW battery tray from Quadratec, because it's specifically made for the hole where the airbox was. Bolts right in. Kinda pricey though...
I pieced together a Spectre intake system, but only because I did a snorkel instead of cowl. That cowl intake system is pretty nice, and all the connections are welded. Good stuff...
I already had a Mean Green alt(200amp), so didn't need anything there.
I went with a Wrangler NW battery tray from Quadratec, because it's specifically made for the hole where the airbox was. Bolts right in. Kinda pricey though...
I pieced together a Spectre intake system, but only because I did a snorkel instead of cowl. That cowl intake system is pretty nice, and all the connections are welded. Good stuff...
#7
Seasoned Member
Join Date: Jul 2011
Location: Murray, UT
Posts: 413
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1999
Model: Cherokee
Engine: 4.0 I6
I've been thinking about this too. But my plan is different. Different intake system, and no fancy battery tray. Just going to mock up a factory one where the air box is. You could also get a dry cell battery and safely mount it in the cabin somewhere. That way it would be easy to hook up an inverter for an air compressor, or something like that.
I'd recommend another alternator, but it may not be 100% necessary. It's my understanding that you would need a battery isolator. Something that connects to the alternator, and splits the amps between the two batteries, and then breaks the connection between the two, so you only draw from one battery at a time(one for deep cycle/all accessories, one for starting.) You can get battery isolators from Quick Cable, and you need to match the isolator to the amount of amps coming out of the alternator.
I haven't looked too hard into it all, because it's not the highest thing on my priority list, but I hope the above info is helpful.
I'd recommend another alternator, but it may not be 100% necessary. It's my understanding that you would need a battery isolator. Something that connects to the alternator, and splits the amps between the two batteries, and then breaks the connection between the two, so you only draw from one battery at a time(one for deep cycle/all accessories, one for starting.) You can get battery isolators from Quick Cable, and you need to match the isolator to the amount of amps coming out of the alternator.
I haven't looked too hard into it all, because it's not the highest thing on my priority list, but I hope the above info is helpful.
Trending Topics
#12
Seasoned Member
Join Date: Sep 2010
Location: Akron, OH
Posts: 440
Likes: 0
Received 0 Likes
on
0 Posts
Year: 1993
Model: Cherokee
Engine: 4.0 HO
#13
Senior Member
Thread Starter
Join Date: Mar 2011
Location: San Antonio, TX
Posts: 643
Likes: 0
Received 0 Likes
on
0 Posts
Year: 2001
Model: Cherokee
Engine: 4.0L
#14
CF Veteran
Join Date: Sep 2009
Location: Summerville, Ga
Posts: 6,322
Likes: 0
Received 5 Likes
on
5 Posts
Year: 1995
Model: Cherokee
Engine: 2.5 4 cyl.
I think there was some truth to what they said, if you're jumping your jeep 5 feet in the air at 80 mph everytime you drive it... Should be fine as long as you're not planning a jeepspeed jeep
#15
Seasoned Member
Join Date: Mar 2011
Location: Richmond
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
Year: 98
Model: Cherokee
Engine: 4.0
Well if you're jumping your XJ like that, then the batteries are not the problem, the force from landing is the problem. Of course you're going to fold the front end like a taco if you jump stuff a lot without reinforcing the unibody rails...That's just common sense.
I beat the crap out of my XJ, and it's doing just fine with two batteries. It feels and drives the same as it did with one battery.
I beat the crap out of my XJ, and it's doing just fine with two batteries. It feels and drives the same as it did with one battery.